Lift Co-Pilot · BS 7121 / LOLER Lift Planner

Point the rear camera at the pick-up zone and landing bay to capture site evidence for the lift plan.

Pick-up zone · not captured

Landing bay · not captured

Voice briefing

en-GB · regex parse

Speech is processed by your browser; text can also be typed.

Load & geometry

Gross load build-up

Load description Net load weight

Weight basis Estimated (+10%) Pick-up radius

Landing radius

Lift height (landing / obstruction)

Rigging headroom allowance

Net load	0.000 t
Contingency (10%, estimated weight)	0.000 t
3-sheave hook block	0.350 t
Slinging gear / accessories	0.120 t
Gross load on hook	0.470 t

Duty chart solver

Liebherr LTM 1060-3.1
12.8 t CW · 6.3 m base 100%

Boom length

–m

Working angle

–°

Chart capacity

–t

Utilisation

–%

0%75%90%100%

Boom	Angle	Tip ht	Cap.	Util.	Status

Engine constants

Carrier + superstructure

Counterweight

Boom pivot height

Max boom angle

Capacities are read conservatively at the next greater tabulated radius (no interpolation). Chart values are indicative for planning and must be verified against the crane's on-board LICCON load chart and the manufacturer's current tables before lifting.

Outrigger & ground bearing

CIRIA C703 · FoS 1.25

Substrate Presumed bearing

kPa

P_max outrigger

–kN

Allowable q

–kPa

Area required

–m²

Applied q (mat)

–kPa

–Standard stock spreader mat, one per outrigger.

P_max = Gross load (kN) + 0.65 × total crane deadweight (kN). Allowable bearing = presumed bearing ÷ 1.25.

Job & lift team

Lift plan header

Site / project Lift plan ref. Lift date Lift category (BS 7121) Site wind limit

m/s

Lift supervisor (A62) Crane operator (A60) Slinger / signaller (A40)

RAMS — generated controls

Condition-driven

Appointed Person gateway

CPCS A61 · LOLER Reg. 8

Appointed Person name CPCS A61 card no. Card expiry

Duty and configuration verified against the manufacturer's load chart / LICCON for the actual rig. Ground conditions, underground services and voids assessed; outrigger mats specified. Crane and lifting accessories hold current LOLER thorough examination reports (Reg. 9). Exclusion zone, overhead hazards and wind limits briefed to the lift team. Lift plan communicated to supervisor, operator and slinger/signaller.

AP signature

Sign above · Appointed Person

Draft · not authorisedComplete all gateway items to authorise.

Important: This tool is a planning aid. Duty chart data is an indicative model of the Liebherr LTM 1060-3.1 (12.8 t counterweight, 6.3 m outrigger base, 100% extension) and ground figures are presumed values. Every lift plan must be reviewed and authorised by a competent Appointed Person under BS 7121-1 and LOLER 1998 before any lifting operation proceeds. Form data is saved on this device only.